Lighting Information - Home Page

Line Voltage Light Bars

Q.Are the Line Voltage Light Bars UL listed?

• Yes they are UL & CUL listed, you can find listed products at www.ul.com.

Q.What is the lamp requirement of the Line Volt Bars?

• They employ JCD Bi-Pin 120V 25W halogen bulbs (supplied with fixture).
  
  Mirdza va lovi aici cu un tabel.

Q.What is the difference between a BA-L1V-2P and a BA-L1V-2?

• The "P" (portable) indicates that the fixture is equipped with a 9' cord and plug to be installed as a portable unit. The BA-L1V-2 is for direct wiring.

Q.For direct wiring, how many knock-outs does the Line Volt Light Bar have?

• Top plate (that mounts onto surface): Two 3/8" knockouts for BX or ROMEX cables.
  Back plate (faces the back splash): Two 3/8" knockouts for BX or ROMEX cables.
  End Cap: one 3/8" knockout and one 1/2" knockout on each end for making continuous runs.
  Fixture is supplied with adapters for trade size Romex & BX connectors.

Q. Can I make a continuous run of 3 Bar Lights? What kind of wire do I need? How far apart can I wire the fixtures?

• Yes - knock-out holes and sufficient length of internal wire are provided so that wiring from one fixture to another is possible. You may use regular BX or ROMEX wires commonly used by electricians. Since these are Line voltage, you may wire them as far apart as you wish without a voltage drop.

Q. Can the BA-LIV's be branch wired and still go on and off independently? If so, how?

• Yes. When branch wired in parallel each bar light functions independently and can be dimmed and turned on and off separately.

Q. Can the under-cabinet lights be dimmed?

• Yes - they have a built-in Hi-Lo switch. When using an additional wall dimmer (a regular incandescent) be sure to leave the Hi-Lo switch at the high setting.

Q. Can I use clear lenses instead of the frosted lenses supplied with the light bars?

• Yes - you may purchase the LENS-BAL-CL to replace the frosted lens. They were fitted with frosted lenses to reduce glare.

Q. Can these fixtures be installed in a damp location?

• Yes - they are suitable for damp locations (above the sink or bathroom), but not wet locations.

Q.Can the light bars be installed above a stove or fire place

• No - the heat will shorten the life of the light bars.

Lighting Information - Home Page